Filter
Top Products
R5976214 VisuPlus Video Insertion Unit June 2003
3-12
3.2.6 RGB Input Unit
VISU
PLUS
can be equipped with RGB input units to insert RGB data. Each of these RGB input units
provides the facility for connecting one RGB source and to loop through the signal.
Connectors
1 RGB in
2 RGB out
Figure 3-16
RGB input unit
An RGB source can be connected to the RGB in [1] connector. If wished the ability to actively loop
through the RGB signal can be used and with the
RGB out [2] connector the signal can be con-
nected to another device.
The RGB out connector may only be used to loop the signal through to connect to
an other device, e.g. a monitor. Don’t insert the signal to another V
ISU
PLUS
. Use an
extra device like RGB/Matrix switcher instead!
If an RGB signal is connected from a Barco Magic interface then a
BNC T-connector has to be used, which has to be connected as close as possible
to the RGB input unit. The Hsync and Vsync line have to be terminated with a 75
Ohm terminator.
In this case only separate sync (HS, VS) may be used. Composite sync (Cs) may
not be used!
Order
The order of the RGB input units is explained in section 3.2.5 Video Input Unit.