Filter
Top Products
MENU STRUCTURE
The IP SETUP MENU is configured as follows:
1. SYSTEM EASY WIZARD
This option will guide you through setting up all required parameters for con-
necting the ITP keyset to your system.
2. SYSTEM INFORMATION
1. Version Info: Provides boot rom, software, DSP, and hardware version
information.
2. Network Info: Displays network mode,IP address of phone,network, and
gateway information.
3. Netmask
4. Gateway
Note that items 2 to 4 are only displayed when setting Manual IP.
3. NETWORK SETUP
This menu allows you to individually setup the same parameters found in the
Easy Wizard.
4. LOAD & UPGRADE SETUP
1. Upgrade TFTP Server:The IP address of the TFTP server containing the ITP
software.
2. Upgrade Start: Starts the ITP software upgrade process.
5. SYSTEM SERVER SETUP
1. Server IP Address:The MCP’s IP address.
2. Server ID:The ID assigned to your ITP (see your phone administrator for
this information).
3. Server Pass:The password assigned to your ITP (see your phone adminis-
tratror for this information).
6. FACTORY RESET
This option resets ITP to factory default settings.
7. REBOOT
This option reboots the ITP.
IP SETUP MENU
To enter the IP SETUP MENU, press the MENU button as soon as the ITP-5121D
phone is connected to the power supply or Power over Ethernet LAN port.
When entering the IP setup menu, the LCD displays the following options:
Other items not shown on screen when scrolling down (press down on navigation
disc):
Once the IP SETUP MENU is displayed,you can move to each menu in the Set Up
by using the navigation buttons.
• The UP and DOWN directions buttons in the navigation button assembly are
used to move the highlighted bar up or down to the desired option.
• The LEFT and RIGHT buttons in the navigation button assembly are used to
move the highlighted bar left or right, to the desired option, move to a sub
menu and if a menu is at the last line,that menu option will be executed.
• The [0]-[9] dial buttons are used to directly choose a menu, or sub menu
options.
• The [ENTER] button in the navigation button assembly is used when saving
a modification.
• The [MENU] button in the navigation button assembly is used to to display
the IP Setup Main Menu.
•The[END] button in the navigation button assembly is used when canceling
or editing the modification, or existing programming.
•The[CANCEL] button in the navigation button assembly is used to go back
to the previous screen or to delete the last digit of a displayed option value.
>1.SYSTEM EASY WIZARD
2.SYSTEM INFORMATION
3.NETWORK SETUP
4.LOAD & UPGRADE SETUP
5.SYSTEM SERVER SETUP
6.FACTORY RESET
10
11
6.FACTORY RESET
7.REBOOT
Home Page
Table of Contents
ITP-5121D