Filter
Top Products
41
CUSTOMIZING YOUR KEYSET
AME PASSWORD
This feature allows customers using the AME feature to enable password protec-
tion. This will prevent unauthorized users from listening to your messages being
left.The passcode is the same as your station passcode.This feature only applies if
there is an Samsung Voicemail card installed in the system and your keyset has a
programmed AME button.
• With the handset on-hook, press TRANSFER and then dial 110.
• Dial 101 to turn on AME PASSCODE or 100 to turn it off.
• Press TRANSFER to store your selection.
AUTO CAMP-ON
This option allows intercom calls to be automatically camped on,if possible,when
a busy station is called.
• With the handset on-hook, press TRANSFER and then dial 110.
• Press 081 to turn CAMP-ON on or 080 to turn it off.
• Press TRANSFER to store your selection.
SELECT RING TONE
Each keyset user can select any one of eight ring frequencies:
• While on-hook, press TRANSFER and then dial 111.
• Dial 1–8 or press the UP and DOWN buttons to hear each tone.
• When you hear the tone that you prefer, press TRANSFER to save it.
NOTE: Specific lines or stations may be programmed to ring with a different
tone than what you have selected for your keyset.
CHANGE YOUR PASSCODE
From the factory, your station passcode is 1234.You can change your station pass-
code whenever you desire.
• While on-hook, press TRANSFER and then dial 101.
• Dial your old passcode.
• Dial a new passcode (must be four characters).You can use 0–9.
• Redial the new passcode to verify. If successful, you will hear two beeps. Four
beeps indicate an incorrect code.Reenter the code again.
• Press TRANSFER to store the new passcode.
NOTES:
1. When you are voice announcing to a station close to you, use the handset to
avoid an echo effect.
2. You cannot off-hook voice announce to single line telephones.
OHVA BLOCK
Your keyset can be programmed with an OHVA Block (BLOCK) button. Pressing
this button will prevent anyone from making an OHVA to you until you press the
button again and cancel the blocking.
OHVA REJECT
Your keyset can be programmed with an OHVA Reject (REJECT) button. Pressing
this button while receiving an OHVA call will disconnect the voice announcing
party and return you to your original call.
IN GROUP/OUT OF GROUP
If your keyset is assigned to a station ring group,you can remove your keyset from
the group and then put it back in.While you are out of the group,you can receive
calls to your extension number but not calls to the group number. If you have an
IN/OUT button with the group number assigned.
• Press the IN/OUT button. It will light red when your keyset is in the group.
• Press the IN/OUT button again to exit the group and turn the light off.Repeat
as necessary.
If you do not have an IN/OUT button:
• Dial the IN/OUT access code number ________________, then the group
number, then 0 to exit the group or 1 to enter the group.
NOTE: If the Hot Keypad feature has been turned off, you must first lift the hand-
set or press SPEAKER button.
The IN/OUT button can include an extender to indicate the specific group that
this button will affect. This means that if you are in multiple groups, you can de-
cide for which groups you will receive calls.
40
Home Page
Table of Contents
ITP-5107S