Samsung DS 5000 IP Phone User Manual


 
1817
PROGRAM SYSTEM SPEED DIAL NUMBERS
The system list starts with 200 numbers and can be increased in blocks of ten.The
system may have either 500 or 950 maximum depending on the setting in MMC
861. See your service company to increase or decrease the system list.
The speed dial codes are 500
999 or 050
999.Each speed dial number consists of
a line access code and the telephone number to be dialed.The access code can be
any line group,individual line,station group or individual extension.The speed dial
number can be up to 24 characters long including , #, FLASH and PAUSE.
NOTE: If Least Cost Routing (LCR) is being used, the LCR access code must be
entered.
When you are entering a speed dial number, there are some special keys that you
will need to use.These are the bottom row of programmable keys on the keysets
and are known as keys A, B, C, D, E and F.
PROGRAM KEYS
UP & DOWN - Select the speed dial bin.
KEYPAD - Used to enter number.
HOLD - Press to clear entry.
SPK/RLS - Save data and advance to next program.
A - Does not have a function.
B - Inserts a FLASH.
C - Inserts a PAUSE.
D - Changes the dialing type from pulse to tone.
E - Hides and displays digits.
F - Changes display to speed dial name entry.
DCS
KEYSETS [NOT SUPPORTED ON OFFICESERV 7100]
PROGRAM STATION GROUP NAMES
This program is used to assign a character name or identification for each station
group.You may assign a name 11 characters long.
PROGRAM KEYS
UP & DOWN - Used to scroll and move cursor.
KEYPAD - Used to enter characters.
HOLD - Press to clear entry.
Open customer programming and follow the instructions below.
ACTION DISPLAY
1. Press TRSF and then dial 602 [5
01] SGR NAME
Display shows the first group
2. Dial the group number (e.g., 505) OR [5
05] SGR NAME
press the UP or DOWN key to make a
selection and press the left or right
soft key to move the cursor
3. Enter the name using the method [505] SGR NAME
in P
rogram Station Names SAMSUNG
4. Press the left or right soft key to return to
step 2 OR press TRSF to store and exit
programming OR press SPK to store and
advance to the next program
A
B
C
D E
F
12 BUTTON KEYSET
PROGRAMMABLE KEYS LAYOUT
A
B C
D
E F
24 BUTTON KEYSET
PROGRAMMABLE KEYS LAYOUT
Home Page
Table of Contents
System Admin