Filter
Top Products
MANUAL RETRY WITH REDIAL
While you are on an outside call listening to a busy signal and you want to redial
the same number dialed.
• Press the REDIAL button.
This will hang up your existing call and manually redial the same number dialed.
You can repeat this operation for a limited number of attempts.
NOTE: If your keyset is programmed with Call Log Blocks then the Redial will
access the call log when pressed.
SAVE NUMBER WITH REDIAL
To save the number you just dialed for later use, press the SNR button before
hanging up.
To redial this saved number at any time,press the SNR button or dial 17.The same
line will be selected for you.
NOTES:
1. If the Hot Keypad feature has been turned off, you must first lift the handset
or press the SPEAKER button before you begin dialing.
2. The saved telephone number is stored in memory until you save another
number.
3. Redial does not apply to intercom calls.
CHAIN DIALING
You may manually dial additional digits following a speed dial number or chain as
many speed dial numbers together as required:
• After the first speed number is dialed, press MEMORY again and dial another
speed number OR manually dial additional digits following a speed dial num-
ber.
AUTOMATIC REDIAL/RETRY
When you are making an outside call and you receive a busy signal, the system
can automatically redial the number for you. It will automatically redial at a pre-
programmed interval for up to 15 attempts.
• When you hear a busy signal, press the RETRY button.
• The system will reserve the line and automatically redial the same number for
you.You will hear the call being made through the keyset speaker.The micro-
phone is muted.
29
For the purposes of pro-
gramming speed dial num-
bers, the programmable but-
tons are known as A,B,C,D,E
and F.
• The A button is not used.
• The B button inserts a
flash.
• The C button inserts a
pause.
• The D button is used for
pulse to tone conversion.If your system uses rotary (or pulse) dialing C.O.lines,
pressing D while entering a speed dial number causes all subsequent digits to
be sent as DTMF tones.
• The E button is used to hide digits. Display keyset users may want to hide
some speed dial numbers so that they will not show in the display.When you
are entering a telephone number, press E. All subsequent digits will be hid-
den. Press E again to begin displaying digits.
• The F button is used to enter a name. S
ee
Personal Speed Dial Names under
Display Features.
• Use the HOLD button to clear a speed dial number.
ONE TOUCH SPEED DIALING
You may assign any speed dial number to an already existing One Touch Speed
Dial button for quick and easy dialing of frequently used numbers.
• While on-hook, press TRANSFER and then dial 107.
• Press a One Touch Speed Dial button.
• Dial the speed dial number (00–49 or 500–999) that you want assigned to
this button.
• Press TRANSFER to store your selection.
To call this telephone number, just press the One Touch Speed Dial button.
NOTE:If the Hot Keypad feature has been turned off,you must first lift the handset
or press the SPEAKER button before you begin dialing.
LAST NUMBER REDIAL
To redial the last telephone number you dialed,press the REDIALbuttonor dial 19.
NOTES:
1. If the Hot Keypad feature has been turned off, you must first lift the handset
or press the SPEAKER button before you begin dialing.
2. Redial does not apply to intercom calls.
28
A B C D E F
Home Page
Table of Contents
ITP-5107S