Filter
Top Products
SETTING THE NETWORK PARAMETERS
Utilize the following programming steps to program the ITP-5107S keyset to
operate within the users network.YOU CAN SELECT THE SYSTEM EASY WIZARD
TO PROGRAM ALL REQUIRED NETWORK PARAMETERS IF YOU WANT TO SET
UP THESE PARAMETERS INDIVIDUALLY FOLLOW THE INSTRUCTIONS BELOW.
Network Parameter Setup
Get int
o the SETUP MODE as sho
wn on page
8. From the Setup,Main Menu,select [3.NET-
WORK SETUP] to set or modify the network
parameters. Scroll to this option using the
volume [▼]~[▲] button and press SPEAKER.
Select the Network Mode Setup and press
SPEAKER, the LCD will display this message.
•If [1. MANUAL IP] is selected,the user must enter the IP address of the IP key-
set. Then enter the subnet mask, and gateway value for the customer net-
work.
•If[2. DHCP] is selected, the IP address, subnet mask, and gateway value will
be obtained automatically (if a DHCP server is present).
Setting IP Manually
• From the “Network Mode Setup” Menu,
select [1. MANUAL IP] and press
SPEAKER. Next, press the HOLD button
twice to get to the NETWORK SETUP
MENU as seen here.
Enter the IP keyset’s IP address, the net-
work’s netmask and gateway as shown.
• Select the [2. IP ADDRESS SET UP]
menu and press SPEAKER, the LCD will
display this message and the user can
enter its IP address.
Check if there is any currently saved IP address of the phone on the LCD. If the IP
address has not been set, the LCD displays nothing. The user can enter the IP
address using [0]-[9] dial buttons and [✱] button for entering a “.” Save that IP
address by pressing the SPEAKER button. Use the HOLD button to backspace.
3.NETWORK MODE SET UP
>1.MANUAL IP
2.DHCP
11
MENU STRUCTURE
The IP SETUP MENU is configured as follows:
1. SYSTEM EASY WIZARD
This option will guide you through setting up all required parameters for con-
necting the ITP keyset to your system.
2. SYSTEM INFORMATION
1. Version Info: Provides boot rom, software, DSP, and hardware version
information.
2. Network Info: Displays network mode,IP address of phone,network, and
gateway information.
3. Netmask
4. Gateway
Note that items 2 to 4 are only displayed when setting Manual IP.
3. NETWORK SETUP
This menu allows you to individually setup the same parameters found in the
Easy Wizard.
4. LOAD & UPGRADE SETUP
1. Upgrade TFTP Server:The IP address of the TFTP server containing the ITP
software.
2. Upgrade Start: Starts the ITP software upgrade process.
5. SYSTEM SERVER SETUP
1. Server IP Address:The MCP’s IP address.
2. Server ID:The ID assigned to your ITP (see your phone administrator for
this information).
3. Server Pass:The password assigned to your ITP (see your phone adminis-
tratror for this information).
6. FACTORY RESET
This option resets ITP to factory default settings.
7. REBOOT
This option reboots the ITP.
10
1.NETWORK MODE SET UP
2.IP ADDRESS SET UP
3.NETMASK SETUP
4.GATEWAY SETUP
INPUT IP ADDRESS & PRESS OK
xxx.xxx.xxx.xxx
Home Page
Table of Contents
ITP-5107S