Filter
Top Products
RECALL DIAL TONE
Hookflash and then dial 18 to disconnect your outside call and receive telephone
company dial tone for a new call.
BUSY LINE QUEUING WITH
CALLBACK
If you receive a busy signal when you select an outside line:
• While on that call, hookflash, receive transfer tone and dial 44.
• When the line becomes free, the system will call you back.
• Lift the handset, receive dial tone and dial the telephone number or the
speed dial number again.
NOTE: A callback will be canceled if it is not answered within 30 seconds.
5
4
OUTSIDE CALLS
MAKING AN OUTSIDE CALL
• Lift the handset and receive internal dial tone.
• Dial a C.O. line or line group access code.
• Receive outside dial tone and then dial the telephone number.
• Finish the call by replacing the handset.
If your system is programmed to require an authorization code before making a
call:
• Dial ✱ and a valid code. You will hear confirmation tone, followed by dial
tone.
• Select a C.O. line.
If your system is programmed to require an account code before making a call:
• Dial 47 and a valid code.
• Hookflash and receive transfer tone. Select a C.O. line.
For more information see your system administrator.
ANSWERING AN OUTSIDE CALL
• Lift the handset. You are automatically connected to the ringing call.
• Finish the call by replacing the handset.
UNIVERSAL ANSWER
Outside lines may be programmed to ring a general alerting device. To answer
calls ringing this device, dial 67. This device can operate in any system ring mode.
SENDING A FLASH
While you are on an outside call, hookflash, receive transfer tone and dial 49 to
send a flash to the telephone company. This may be required for some custom call-
ing features or CENTREX lines.
Note: Flash is not available on an ISDN circuit.
Home Page
Table of Contents
STD Telephone