Samsung DS 5000 IP Phone User Manual


 
3029
PROGRAMMING ACCOUNT CODES
This program is used to add or change account code entries.
PROGRAM KEYS
KEYPAD - Used to enter the account code (allowable digits 0–9).
UP & DOWN - Used to select entry number.
FLASH & TRSF - Used to view and change only the used entries.
SPK/RLS - Used to clear data.
Open customer programming and follow the instructions below.
ACTION DISPLAY
1. Press TRSF and then dial 708 ACCOUNT CODE
Display shows (0
01)
2. Dial the account code entry (e.g.,005) ACCOUNT CODE
OR press UP or DOWN to select the (0
05)
entry number and press the right soft
key to move the cursor
3. Enter the account code via the dial pad, ACCOUNT CODE
e.g., 1234 (maximum of 12 digits) and (005)1
23456789012
press the right soft key to move the
cursor back to step 2
4. Press TRSF to store and exit pro-
gramming OR press SPK to store and
advance to the next program
STATION TIMERS
Each station can have five timers customized for them to accommodate station
users with individual work habits.These timers are as follows:
NO ANS FWD No Answer Forward
This is the amount of time a call will ring at a station before it forwards to the
Forward No Answer destination.The default is 15 seconds and the range is 000 to
250 seconds.Make sure that this timer is not set to a greater value than the trans-
fer recall timer or transferred calls will not forward.
DTMF DUR. DTMF Duration
This is the duration of DTMF tones sent to an analog voice mail port. The default
duration is 100 milliseconds and the range is 0100 to 9900 milliseconds.
F-DGT DELY First Digit Delay
This is the time the system will wait before sending DTMF digits to a voice mail
port. The default time is 600 milliseconds and the range is from 100 to 9900 mil-
liseconds.
OFFHK SEL. Off Hook Select
This timer controls the delay between going off hook (lifting the handset) and the
off hook select destination being called.The default duration is 10 seconds and the
range is from 000 to 250 seconds.
EFWD DELAY External Forward Delay
This is the time that a station will ring before a call forwards to the external call for-
ward destination.The default duration is 10 seconds and the range is 1 second to
250 seconds.
Open customer programming and follow the instructions below.
PROGRAM KEYS
KEYPAD - Used to set timer values.
UP & DOWN - Used to select extension number.
SPK/RLS - Save data and advance to next program.
ACTION DISPLAY
1. Press TRSF and then dial 502 [2
01] NO ANS FWD
Display shows 010 SEC
Home Page
Table of Contents
System Admin