Filter
Top Products
13
SECURING
SCREWS
REMOVE
KNOCKOUTS
ADDING AN
iDCS 14 BUTTON KEY STRIP
• Place the keyset face down on a flat surface.
• Remove the base pedestal by placing your thumbs over the attachment clips
and press outward while simultaneously pressing down on the keyset body
with your fingertips.
• Remove the ribbon cable knockout from the bottom of the keyset.
• Clip the 14 button strip to the side of the keyset.
• Plug one end of the ribbon cable into the keyset and the other end into the
14 button strip.
• Place the support bracket over the ribbon cable and secure with the six
screws provided.
• Reattach the base pedestal.
ADDING A KEYSET
DAUGHTERBOARD MODULE
• Place the keyset face down on a flat surface.
• Remove the base pedestal by placing your thumbs over the attachment clips
and press outward while simultaneously pressing down on the keyset body
with your fingertips.
• Remove the two knockouts from the bottom of the keyset.
• Plug in the daughter module and secure with the two screws provided.
12
REMOVE KNOCKOUTS
CONNECT RIBBON CABLE
Home Page
Table of Contents
iDCS Keyset