Filter
Top Products
1211
CHANGING FEATURE PASSCODE
You can change individual feature passcodes.This program is used to change the
passcodes for several features. These features are the following: RING PLAN SER-
VICE, DISA ALARM, ALARM CLEAR, and AA RECORD. Note: Each passcode is four
digits long.Each digit can be 0 to 9.
PROGRAM KEYS
UP & DOWN - Select the extension number.
HOLD - Press to reset the passcode to default settings.
Open customer programming and follow the instructions below.
ACTION DISPLAY
1. Press TRSF and then dial 202 CHANGE PASSCODE
Display shows R
ING PLAN: 0000
2. Use the UP and DOWN keys to scroll CHANGE PASSCODE
through the different options and press D
ISA ALARM:5678
the right soft keys.
3. Press HOLD to reset the passcode CHANGE PASSCODE
RING PLAN: 0
000
4. Press TRSF to store and exit programming
OR press SPK to store and advance to the
next program
SET DATE AND TIME DISPLAY
Should it ever become necessary to correct the date and time displayed on all of
the keysets, do so as soon as you notice that they are incorrect. Automatic
Operating Mode will not work correctly and SMDR records will be of no value
when the date and time are not correct.
The display format is the following:
W (Day of the week):Enter 0 for Sunday and 6 for Saturday.
MM (Month): Enter 01 for January and 12 for December.
DD (Day of the month): Enter a number in the range of 01–31.
YY (Year): Enter the last two digits of the year.
HH (Hours): Use the 24 hour clock and enter a number in the range of 00–24.
MM (Minutes): Enter a number in the range of 00–59.
Failure to enter the time using the 24 hour clock will cause the date to change at
12:00 P.M. Open customer programming and follow the instructions below.
ACTION DISPLAY
1. Press TRSF and then dial 505 OLD:6010184:0047
Display shows NEW:WMMDDYY:HHMM
2. Enter the new time and date using OLD:6010184:0047
the above format NEW:3020994:1445
3. Verify the time and date and reenter OLD:3020994:1445
them if necessary NEW:WMMDDYY:HHMM
4. Press TRSF to store and exit
programming OR press SPK to store
and advance to the next program
If you have entered invalid data,you will receive an [ INVALID ENTRY ] message for
three seconds.Reenter the correct date and time.If the information you entered is
incorrect, repeat the procedure.
RESET STATION PASSCODES
TO DEFAULT
Individual keyset users can set or change their own individual passcodes. These
passcodes are used to lock and unlock keysets, override toll restriction and access
the DISA feature. At times, it may be necessary for the system administrator to
reset a station’s passcode to default “1234.”This program cannot be used to display
passcodes,only to reset them.
PROGRAM KEYS
UP & DOWN - Select the extension number.
HOLD - Press to reset the passcode.
Open customer programming and follow the instructions below.
ACTION DISPLAY
1. Press TRSF and then dial 101 [201
] PASSCODE
Display shows PASSCODE:✱✱✱✱
Home Page
Table of Contents
System Admin