Filter
Top Products
11
OUTSIDE CALLS
MAKING AN OUTSIDE CALL
• Lift the handset and press an idle outside line button,line group button or dial
a line access code to receive dial tone—OR—press an idle outside line button,
line group button or dial a line access code to receive dial tone through the
speaker—OR—press SPEAKER, receive intercom dial tone and dial a line
access code.
• Dial the telephone number.
• Finish the call by replacing the handset or pressing the END button.
NOTE: You will receive No More Calls tone when you attempt to make a call and
there is no button available for that line.
• If Least Cost Routing is enabled on your phone system, this button may be
labeled LCR or accessed by dialing an access code (usually 9).
• If your system is programmed to require an authorization code before making
a call, dial ✱ plus a valid code before selecting a C.O. line.
• If your system is programmed to require an account code before making a
call, press the ACC button or dial 47 plus a valid bin number, press the ACC
button again and then select a C.O.line.See Account Codes for more information.
For more information on authorization and account codes, see your system
administrator.
NOTE:If the Hot Keypad feature has been turned off,you must first lift the handset
or press the SPEAKER button before dialing.
ANSWERING AN OUTSIDE CALL
• Lift the handset and you are automatically connected to the ringing call.
S
ee
Ring Preference under Customizing Your Keyset—OR—press the SEND but-
ton to automatically answer on the speakerphone.
NOTE: If a call is flashing at your keyset but not ringing, you must press the flash-
ing button to answer.
UNIVERSAL ANSWER
Outside lines may be programmed to ring a general alerting device. To answer
calls ringing this device,dial 67 or press the UA button.This device can operate in
any one of the six different ring plans.
NOTE:If the Hot Keypad feature has been turned off,you must first lift the handset
or press the SPEAKER button before dialing.
10
DS 5000 SETUP
MENU STRUCTURE
The SETUP MENU is configured as follows:
1. INFORMATION
1. Outgoing
2. Incoming Log
3. Speed Dial
4. Directory Dial
5. Forward Set
4. Alarm Reminder
NAVIGATING THE MENUS
When programming within various menu options,information can be entered via
the dial pad keys using [0]-[9] and [✱] dial keys, as well as utilizing the navigation
button assembly.
The button used for editing and their features are summarized below.
BUT
TON FEATURES
Left and Right ......................To move a cursor (highlighted area) or to erase what is
entered.
Enter ........................................To save the current setting and end programming.
End............................................To cancel the current programming and return to the
Main Menu.
Cancel......................................To move back to the previous screen or delete the last
digit of the displayed option value.
[0]-[9] ......................................To enter numerical values.
NOTE:The DS5007S keysets do not support the navigation key function.
Home Page
Table of Contents
DS 5000