Samsung DS 5000 IP Phone User Manual


 
11
ASSEMBLING YOUR KEYSET
Place the keyset face down on a flat surface.
Remove the base pedestal by placing your thumbs over the attachment clips
and press outward while simultaneously pressing down on the keyset body
with your fingertips.
Plug the handset cord into the jack marked with the symbol.
Route the handset cord out the RIGHT side of the keyset as you look at it face
down.
Reattach the base pedestal.
Plug the line cord into the jack on the base of the keyset marked with the
symbol and route it through one of the cable channels in the bottom
of the base pedestal.
KEYSET DAUGHTER MODULES
[28 AND 18 BUTTON KEYSETS ONLY]
iDCS 28D and 18D button keysets can have one of three different types of daugh-
ter module installed on them to enhance the operation of the keyset or to provide
an additional local port depending on the type of module.
iDCS KDB-DIGITAL LINE
INTERFACE (FKDBD)
[NOT SUPPORTED ON OS 7100]
If your keyset is connected to a Digital Line Interface (DLI) port that supports 2B+D
operation (your installing company can determine this) you may install a daugh-
ter module that provides a Digital Line Interface (DLI) port for connection of a dig-
ital station device such as a keyset or 64 button module.
iDCS KDB-SINGLE LINE
INTERFACE (FKDBS)
[NOT SUPPORTED ON OS 7100]
If your keyset is connected to a Digital Line Interface (DLI) port that supports 2B+D
operation (your installing company can determine this) you may install a daugh-
ter module that provides a Single Line Interface (SLI) port for connection of a stan-
dard telephone device such as a cordless phone.[NOT SUPPORTED ON OfficeServ
7100]
iDCS KDB-FULL DUPLEX (FKDBF)
The standard speakerphone mode of operation for a iDCS keyset is “half duplex”.
This means that you cannot transmit and receive speech at the same time.Adding
a FKDBF to your keyset will convert the speakerphone into full duplex mode
enhancing its operation. In addition the FKDBF may have up to three (3) external
microphones attached to it for conference room type applications. These micro-
phones require an “EXTMIC”key programmed on the keyset to activate or deacti-
vate them.
10
Home Page
Table of Contents
iDCS Keyset