Filter
Top Products
CUSTOMIZING YOUR KEYSET
AME PASSWORD
This feature allows people using the AME feature to enable password protection.
This will prevent unauthorized people from listening to your messages being left.
The passcode is the same as your station passcode. This feature only applies if
there is a SVMi card installed in the system and your keyset has a programmed
AME button.
• With the handset on-hook, press TRANSFER and then dial 110.
• Dial 101 to turn on AME PASSCODE or 100 to turn it off.
• Press TRANSFER to store your selection.
From the LCD:
• Press MENU button.
• Scroll to SETUP option and press ENTER.
• Scroll to STATION ON/OFF and press ENTER—OR—you may dial 6 and
immediately enter the option.
• Scroll to AME password and press ENTER to change status.
• Press CANCEL to return to the Main Option Page—OR—press END to return
to the idle screen.
AUTO CAMP-ON
This option allows intercom calls to be automatically camped on,if possible,when
a busy station is called.
• With the handset on-hook, press TRANSFER and then dial 110.
• Press 081 to turn CAMP-ON on or 080 to turn it off.
• Press TRANSFER to store your selection.
From the LCD:
• Press MENU button.
• Scroll to SETUP option and press ENTER.
• Scroll to STATION ON/OFF and press ENTER—OR—you may dial 6 and
immediately enter the option.
• Scroll to AUTO CAMP-ON and press ENTER to change status.
• Press CANCEL to return to the Main Option Page—OR—press END to return
to the idle screen.
4948
OHVA BLOCK
Your keyset can be programmed with an OHVA Block (BLOCK) button. Pressing
this button will prevent anyone from making an OHVA to you until you press the
button again and cancel the blocking.
OHVA REJECT
Your keyset can be programmed with an OHVA Reject (REJECT) button. Pressing
this button while receiving an OHVA call will disconnect the voice announcing
party and return you to your original call.
IN GROUP/OUT OF GROUP
If your keyset is assigned to a station ring group,you can remove your keyset from
the group and then put it back in.While you are out of the group,you can receive
calls to your extension number but not calls to the group number. If you have an
IN/OUT button with the group number assigned.
• Press the IN/OUT button. The button indicator will be lit steady when your
keyset is in the group.
• Press the IN/OUT button again to exit the group and the indicator will go
blank. Repeat as necessary.
If you do not have an IN/OUT button:
• Dial the IN/OUT access code number ________________, then the group
number, then 0 to exit the group or 1 to enter the group.
NOTE: If the Hot Keypad feature has been turned off, you must first lift the hand-
set or press SPEAKER button.
The IN/OUT button can include an extender to indicate the specific group that
this button will affect. This means that if you are in multiple groups, you can de-
cide for which groups you will receive calls.
Home Page
Table of Contents
ITP-5112L