Filter
Top Products
DCS INTRODUCTION
COMBINED PROGRAMMING MANUAL NOVEMBER 2001
1-3
1.3.3 Station Level
The system administrator or keyset user can access certain programs at a station with-
out using a passcode. At this level, only data for the selected station can be changed.
You should refer to the instructions provided in the Samsung DCS Keyset User Guide.
• Accessible MMCs at this level are nos. 100–121.
1.4 Keys Used for Programming
Programming may be done from any 6-button (6B), 12-button (12B) or 24-button (24B)
keyset with a liquid crystal display (LCD). (Refer to the Samsung DCS Keyset User Guide
for a full description of keyset operation.)
1.4.1 Soft Keys
The three keys directly below
the LCD are called soft keys.
The left-hand soft key is desig-
nated as the LEFT soft key. This
key is used to save any
changed data while program-
ming, or to move the cursor to
the left on the LCD.
The right-hand soft key is des-
ignated as the RIGHT soft key.
This key is used to save any
changed data while program-
ming, or to move the cursor to
the right on the LCD.
DCS Euro Display Keysets
1.4.2 Other Keys
The following keys perform special functions:
VOLUME UP (+) / DOWN (–) Scroll up/down through available options*
KEYPAD Enter data using keys 0–9 and [, and dial options*
HOLD Clear previous entry
ANS/RLS Select “ALL” option (e.g. to make data apply to all,
rather than selected, stations)
SPEAKER Store data and advance to next MMC
TRSF Enter programming mode or
Store data and exit programming mode
* Note: Many MMCs allow you to dial codes using the keypad to select options quickly. Alterna-
tively, you can press the VOLUME Up and Down keys (+ and –) to scroll through and select op-
tions. Use whichever method you prefer.