Filter
Top Products
DCS MMC PROGRAMS
COMBINED PROGRAMMING MANUAL NOVEMBER 2001
MMC 603 (Page 1 of 2)
MMC: 603 ASSIGN TRUNK GROUP
DCS
33
CI
33
CII
33
816
33
408i
33
408
33
Allows the assignment of trunks to a specific trunk group or to several trunk groups. This is very
useful for programming of LCR when more than one trunk is to be in several dialling plans. There
are two different modes of operation: (1) sequential and (2) distribute.
WARNING: One trunk can appear in more than one trunk group. If necessary, delete the trunk
member from other groups to prevent accidental access.
The number of trunk groups is:
DCS and Compact II — 11: valid groups are 9 and 80–89.
816 — Four: valid groups are 9 and 80–82.
408/408i — Two: valid groups are 9 and 8.
Valid number of members of trunk groups are:
DCS: 01–80
Compact I: 01–10
Compact II: 01–40
816: 01–10
408/408i: 1–4
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
ANS/RLS Used to select ALL
ACTION DISPLAY
1. Open programming and select 603
Display shows (e.g. trunk group 9)
[9
] TRK GROUP
MODE:SEQUENTIAL
2. Enter in valid trunk group (see above)(e.g. 81)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to advance cursor
[81] TRK GROUP
MODE:SEQUENTIAL
3. Press RIGHT soft key to change mode
OR
Press UP or DOWN key to change mode to member
[81] TRK GROUP
MEMBER 01:NONE
4. Press RIGHT soft key to move cursor to number of
member and enter valid member number (e.g. 04) via
dial keypad
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor
[81] TRK GROUP
MEMBER 04:NONE