Filter
Top Products
DCS MMC PROGRAMS
COMBINED PROGRAMMING MANUAL NOVEMBER 2001
MMC 810 (Page 1 of 2)
MMC: 810 HALT PROCESSING
DCS
33
CI
33
CII
33
816
33
408i
77
408
77
Used only in the event that all data processing needs to be stopped in either a single cabinet or
slot, or in the entire system. The procedure differs slightly between systems.
Note: You do not need to enable system programming (MMC 800) in order to run this program but you will
still require the technician’s passcode.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
ANS/RLS Used to select ALL
n DCS PROCEDURE
ACTION DISPLAY
1. Open programming and select 810
Display shows
HALT/PROCESSING
C:ALL S:ALL→PROC
2a. Enter cabinet selection via dial keypad
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to advance cursor
HALT/PROCESSING
C:3 S:ALL→PROC
2b. Press ANS/RLS to select all cabinets and all slots
HALT/PROCESSING
C:ALL S:ALL→PROC
3. Enter slot number via dial keypad
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to advance cursor
HALT/PROCESSING
C:3 S:5 →PROC
4. Enter 1 for HALT or 0 to PROC
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to enter data and return to step 2
HALT/PROCESSING
C:3 S:5 →HALT
5. Press TRSF to store and exit
OR
Press SPEAKER to store and advance to next MMC