Filter
Top Products
Auto Set Relocation System Features
1-8 DBS 824-3.0/3.2-700 Revised April 2000
• When one auto mode is turned on, the mode cannot be reset by the
DAY/
NIGHT1/NIGHT2
,
NIGHT
key or
NIGHT2
key until 3 minutes after the
auto mode is activated. (When both auto modes are set, the mode keys
cannot be used.)
• If mode keys are not assigned, the access codes #520 (DAY/NIGHT1/
NIGHT2 toggle), #521 (Day), #522 (Night1) and #523 (Night2) can be
used instead.
Auto Set Relocation
(CPC-S and CPC-M)
Description
Auto Set Relocation can be used to relocate the program settings of one
extension to another extension.
Auto Set Relocation is commonly used when extension users want to trade
work areas. For example, if Extensions “A” and “B” are going to switch
office locations, Auto Set Relocation enables them to switch telephone
settings without re-programming.
Operation
Before a phone can be relocated, it must be assigned an Auto Set Relocation
code. See “Related Programming” for the program address used to set up the
Auto Set Relocation Code.
The following example illustrates how the program settings for extensions
200 and 300 could be switched.
To Transfer Extension Settings from 200 to 300:
1. At extension 200, pick up the handset.
2. Press “#10.”
3. Dial extension number 300.
4. Enter the four-digit auto set relocation code assigned to extension 300.
5. Replace the handset.
• All programmed extension features, TRS, and LCR settings from 200
are transferred to 300.