Filter
Top Products
2.0 Features Update Appendix A
A-8 DBS 824-3.0/3.2-700 Revised April 2000
Notes
Available on small-display phones only.
This feature applies to the 44-series
small-display phone only (i.e., phones with a 2-line LCD display).
Incompatibility with older phone versions.
Directory Mode is available on the
44-Series phones only.
Hot Dial Pad and Directory Mode.
The Hot Dial Pad feature (FF3 ExtPort# 47#)
will not work on an extension in Directory Mode.
Variable Mode
44-Series phones only
CPC-S/M Version 2.0 and higher
Description
This feature applies to the 44-series small-display phone only (i.e., phones with a
2-line LCD display).
When the phone is in Variable Mode, the features for Flexible Function Screen
select keys 1 and 2 will display during each of the following call states:
Call State Existing Program Address*
• During an intercom call FF3 (ExtPort)# 28# (25-39)#
• During CO dial tone FF3 (ExtPort)# 29# (25-39)#
• During a trunk call FF3 (ExtPort)# 30# (25-39)#
• After dialing a busy extension FF3 (ExtPort)# 33# (25-39)#
* In these addresses, you assign a Flexible Function Screen (25-39) to appear on
the extension while it is in the call state.
Operation
The select keys on the 44-series small-display phone are labeled “>” and “<“ to the
left and right of the display’s 2nd line. Pressing select key 1 (“>” on the left) or
select key 2 (“<“ on the right) will perform the displayed feature.
To use Variable Mode:
1. Activate Variable Mode by pressing
ON/OFF *61 ON/OFF
.
• When you dial
*61
in the above sequence, the 1st line of the LCD
will display “Variable md ON”. The display will return to normal
when you press the second
ON/OFF
.
• Use existing addresses FF1 2# 7# 2# to assign screen text.
• The
*61
code toggles Variable Mode on and off. Press
ON/OFF *61
ON/OFF
again to turn Variable Mode off.
2. While the extension is engaged in an intercom call, the 2nd line will
display select key 1 and 2 features from the Flexible Function Screen