Filter
Top Products
Key Telephone Features One-Touch VM Access
Revised April 2000 DBS 824-3.0/3.2-700 3-65
• A One-Touch key can be programmed to automatically access a CO line
before dialing a personal speed dial number.
• Select an outside line group when you program a One-Touch key. A free
line is selected from that group when you dial out. (Group 9 can be
programmed to select LCR automatically.) The following table shows the
available outside line groups and their corresponding code numbers:
Table 3-7. One-touch access codes for trunk group numbers
• One-Touch keys cannot be checked while Station Lockout is set.
One-Touch VM Access
(CPC-S and CPC-M)
Description
One-Touch VM Access simplifies voice message retrieval for personal
mailboxes as well as attendant transfer of incoming calls to extension
mailboxes.
For instructions on attendant usage of the VM key, see “One-Touch VM
Access” on page 3-65.
One-Touch VM Access allows a user to program an FF key, DSS key, or
One-Touch key to automatically dial voice mail. The extension number for
voice mail as well as the user’s password can be stored under the key.
If the voice mail key is assigned to an FF key or DSS key, the voice mail key
and the MSGE lamp will flash red when the user has a message. (With a One-
Touch key, only the MSGE lamp flashes.) To access his or her mailbox, the
user simply presses the voice mail key.
Trunk Group Number Code Number to be entered
81 1
82 2
83 3
84 4
85 5
86 6
99