Fujitsu SRS-9924-ABM Telephone User Manual


 
5-8
5
NI / 5E Custom Terminal Installation
NI ONLY
Key Attribute
Configuration
CACH uses Call Appearances for telephone numbers
and feature numbers for features. You enter these
numbers with options 1 and 2 of KEY-ATTR.
Before attempting to load or modify network data,
obtain the current configuration from your service
provider. This configuration information should
show the Directory Numbers/Call Appearances, the
features (with their feature numbers), and the
terminal button to which each Directory Number/
Call Appearance or feature is assigned.
Button assignments fall into three categories:
Directory Numbers, Call Appearances, and Features.
If you must manually configure your set, or if you
want to rearrange the button assignments on your
set, you must use the following method.
If you plan to change a button assignment from
one category to another (e.g. Call Appearance to
Directory Number) you must first cancel the current
assignment and add the new assignment. For
changes within a category (call forwarding to call
pick-up), simply replace the old data with the new
data.
To load, modify, or update your set’s network data,
begin with these steps:
1.
OPTIONS
9 ENTER
KEY ATTRIBUTE MODE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.
ENTER
1: DL 2: MANUAL
SELECT ITEM (1-2)
You can either automatically download the
configuration or set-up each item manually. Each
method is described in the following sections.
Key Attribute selection 1, “Downloading”, may be
used to request a download after initial installation.
Download