Filter
Top Products
2-10
2
Using the Terminal
TRANSFER
<DMS-100, NI1>
Transfers a call
to another
phone
To transfer a call, follow these steps:
1. While still on the call, press CONF.
The CONF button indicator lights up. The call is
put on hold and its CA indicator flashes red.
2. An idle CA/DN is selected. Dial the number of
the person you want to transfer the call to.
• If the person answers, you can talk privately
before completing the transfer.
• If the line is busy or the person does not
answer, press the button in the handset
cradle (press SPKR if you are using handsfree
mode). Then press the flashing CA button
to return to the original call.
Note: To do a “blind” transfer, where you do
not talk to the person you are transferring
the call to, wait for the person’s phone to
ring, press the TRAN button, and hang up.
3. After announcing the transfer, press TRAN and
hang up.
4. Hang up the handset, or, in handsfree mode,
press SPKR.
You are disconnected from the call, leaving the other
two parties connected.
Note: The DMS-100 NI1, the transfer procedure
is different. On NI1, press CONF as the first
step, then follow the preceding instructions.
Note: In Siemens installations, transferring calls
is accomplished without a TRAN button.
To transfer a call, follow these steps:
1. While on an active call, press CONF.
The CONF button indicator lights up. The call is
put on hold, and its CA indicator flashes red.
2. An idle CA is selected. Dial the number of the
person you want to transfer the call to.
• If the person answers, you can talk privately
before completing the transfer.
TRANSFER
<EWSD>
Transfers a call
to another
phone