Fujitsu SRS-9924-ABM Telephone User Manual


 
3-20
3
Using the NI / 5E Custom Terminal Set-Up
2.
ENTER
1: ALL 2: SELECT
3: NO SUPPORT (SELECT 1-3)
3. Press 1 or 2, then ENTER. If you selected 2, the
following screen appears:
SUPPORTED (SELECT)
SELECT ASSIGN KEY
4. All LEDs will light green if “All” was previously
selected. Only CAs with lit LEDs will activate
on Call Announce. Press the buttons to turn
the LEDs on or off to select the desired CA
button(s).
5.
ENTER
SUPPORTED (SELECT/ALL)
COMPLETED
After selecting the CA buttons that are to be auto
answered, you may proceed to select DNs for Call
Screeners.
When enabling the feature, you must specify a DN,
to be used by the screener to activate the recipient’s
intercom. All recipients can specify the same DN,
for all CA Intercom calls.
Normal calls can still be made from this DN to
numbers not set up for intercom. Up to three DNs
may be programmed.
When specifying the DN for intercom, you must
enter all ten digits of the call screener number. For
example, for a call screener at 926-3112, you could
enter:
919 926 3112
or
919*926*3112
Specifying the
Directory
Number for
Intercom