3-18
3
Using the NI / 5E Custom Terminal Set-Up
5E CUSTOM ONLY
If you have previously assigned a button as the
delimiter key, its indicator turns green when you
complete step 2. You have two choices at this point:
• If you press a different button and press ENTER,
the indicator of the previously assigned button
goes off and the indicator of the new button
turns green. The number of the new button
appears on the display.
• If you press the previously assigned delimiter
button and press ENTER, you cancel the button
as the delimiter key. Its indicator goes out.
After you assign (or cancel) a button, the screen
looks like this:
DELIMITER KEY = (17)
COMPLETED
If you have canceled a button, the end of line 1
includes the word CANCEL.
Note: The SRS-9924 utilizes either two-way or one-
way intercom. The SRS-9912 utilizes one-way
intercom.
The Call Announce Intercom feature is a convenient
way to screen incoming calls, then announce the
call to the intended recipient. The screener places
the incoming call on hold, uses a designated DN
to announce the call to the recipient via intercom,
and may then transfer the call. The screener can
also use this feature to deliver a message.
The Call Announce Intercom operates in one of two
modes, two-way or one-way intercom. Two-way
intercom immediately activates the speaker and
microphone of the called digital set, allowing two-
way communication.
One-way intercom activates only the speaker,
leaving the microphone of the recipient’s digital set
turned off in the interest of privacy. The recipient
must press the MIC-OFF button to respond to the
call screener.
CALL ANNOUNCE
INTERCOM