Fujitsu SRS-9924-ABM Telephone User Manual


 
SRS-9912 and SRS-9924
QUICK REFERENCE CARD
To Make a Call
1. Press idle CA (Call Appearance) and pick up the
handset. (For handsfree mode, press SPEAKER.)
2. Dial the number.
To Place One-Touch Calls
Press a one-touch button. (If no idle CA LED lights, press
any idle CA.)
To Answer a Call
1. Press the green-flashing CA.
2. Pick up the handset. (For handsfree mode, press
SPEAKER.)
To Put a Call on HOLD
1. Press HOLD.
2. To get a dial tone, press an idle CA; to connect with
another call press a lit or blinking CA.
3. To reconnect with call on hold, press its CA.
To Set Up a CONFERENCE Call
1. While on an active call, press CONFERENCE.
2. Another CA/DN will be selected automatically and
you will hear the dial tone.
3. Dial the third party.
OR
4. Press any CA/DN that is ringing or on HOLD.
5. Press CONFERENCE.
Repeat steps 1-3 to add more calls. To disconnect last
call added, press DROP. Other participants can drop
out by hanging up. At some installations if you drop
out, the entire conference is disconnected. Ask your
Systems Administrator.
To Use Call Pickup
1. Get a dial tone.
2. Press CALL PICKUP feature button.
To Review Unanswered Call List (UNA)
1. When a
UNA appears on the displays, press UNA
(softkey 1). Information from the oldest unanswered
call appears.
2. Press UNA again. Information from the next-to-oldest
unanswered call appears. After displaying most
recent call, display returns to the oldest call.
3. To delete displayed call information, press # on the
keypad, then CLEAR (softkey 3).
To Use Personal Directory
1. Press L-DIR.
2. Scroll to the name and number you want to call, using
the * key to scroll up and the # to scroll down. The
> should be next to the Name you want to call.
You may also dial the two-digit code (e.g. 02)
associated with the name or number.
3. Lift the handset or press the speaker button.
To Switch To/From Handsfree
To switch to handsfree, press SPEAKER and replace
handset in cradle. (If multifunction button 30 is active
as MIC-OFF, its LED must be dark to talk; if its LED is lit,
press MIC-OFF.)
To switch to handset, pick up handset.
To Change Call Volume
With a CA active (LED on), press repeatedly to increase
volume, press repeatedly to decrease volume. Volume
is held until reset.
To Adjust Display (When No Call is Active)
Press repeatedly to increase contrast.
Press repeatedly to decrease contrast.
To Use MIC-OFF (9924 only)
To mute handset or the handsfree microphone, press
MIC-OFF (LED lights). Press again to turn microphone
on (LED goes dark).
To Program a One-Touch Button
1. Press OPTIONS (softkey 4), 1 on the keypad, then
ENTER (softkey 1).
2. Press the button you want to make a one-touch. (Do
not reuse CA FA keys. Or press an existing one-touch
button to change its recorded number.)
3. Dial the numbers you want that button to send.*
4. Press ENTER. (COMPLETED appears on display.)
5. To exit, press OPTIONS.
*Use the HOLD button to insert pauses.