Filter
Top Products
94 CHAPTER 7: GETTING MORE FROM YOUR TELEPHONE SYSTEM
OR
■ For only the next single external (outbound) call that you dial
Your administrator can configure your system so that CLIR is always
active, in which case you cannot change the CLIR settings on your
telephone to override this option.
CLIR for All External Calls
To enable CLIR-All for all calls from your telephone:
1 Pick up the handset, and press Feature + 889. The display panel on your
3Com Telephone shows CLIR-ALL on.
2 Dial the number that you want to call.
The NBX system does not send caller ID information on this call or any
future calls until you disable this feature.
To disable CLIR-All:
1 Pick up the handset.
2 Press Feature + 889 again. CLIR-ALL off appears briefly in the display
panel and then disappears when you hang up the handset.
To view your current CLIR-All setting, log in to the NBX NetSet Utility and
go to My Calling Privileges >
Feature Settings.
CLIR for Next External Call Only
To enable CLIR for only the next call from your telephone:
1 Pick up the handset.
2 Press Feature + 890. The telephone display panel shows CLIR-NEXT on.
3 Dial the number that you want to call.
4 When you disconnect the call, the CLIR feature is no longer in effect.
CLIR-NEXT on disappears from the display panel.
If you hang up the handset without making a call, the CLIR-NEXT feature
remains active and will apply to the next external call that you make. If
you are unsure about whether CLIR-NEXT is active, pick up the handset,
press Feature + 890, and read the status message in the display panel of
your telephone.