Filter
Top Products
Do Not Disturb 85
Do Not Disturb When the Do Not Disturb feature is in effect, calls coming in to your
telephone immediately go to your default call coverage point without
ringing. You set the default call coverage point from the NBX NetSet
utility by going to Call Forward > Call Forward. See
“Forwarding
Incoming Calls” in Chapter 5.
If Call Forward All is in effect, it overrides Do Not Disturb. Calls go to the
call coverage point defined for Call Forward All in the Call Forward >
Call Forward Override page.
You may be able to map the Do Not Disturb feature to an available
Access button on your 3Com Telephone (see the
“User Button
Mapping”section, or you can use the Feature Code to enable and disable
the feature.
When Do Not Disturb is in effect:
■ It overrides Call Forward No Answer, Call Forward Busy, and FWD
MAIL.
■ Your telephone does not ring when it receives an incoming call.
If you use a 3Com Attendant Console, the associated status light does
flash when a call arrives.
■ You can use the telephone to dial outgoing calls.
■ You can use the telephone to dial internal and external pages.
■ If your telephone is part of a call pickup group, no other telephone in
the pickup group can retrieve a call that comes directly in to your
telephone. The incoming call goes immediately to the call coverage
point (voice mail, auto attendant, or other extension).
■ If your telephone is part of an ACD group, a hunt group, or a calling
group, incoming calls to the group ring on your telephone. Calls
coming in directly to your telephone (not directed to the group) do
not ring on your telephone. To prevent every call from ringing, you
must enable Do Not Disturb and also log out of the group.
To enable and disable Do Not Disturb using the feature code:
1 Pick up the handset and press Feature + 446.
2 Hang up. Your telephone is now in Do Not Disturb mode. The display
panel on a 3Com Telephone shows DO NOT DISTURB.