Uniden EXP1240 Two-Way Radio User Manual


 
EXP1240 System Installation Guide Revision 06
© 2013 Uniden America Corp. PROPRIETARY AND CONFIDENTIAL Page 53 of 71
Parameter Description
Registrar
Enter the IP address of the SIP server optionally followed by the port
number you want the base to use. Use one of the following formats:
IP address (e.g., 192.168.0.1
{IPaddress}:{port} (e.g., 192.168.0.1:5060).
Outbound
Proxy
Enter the IP address and port of the Session Border Controller DNS or
the SIP server outbound proxy address. Use one of these formats:
IP address (e.g., 192.168.0.1)
{IPaddress}:{port} (e.g., 192.168.0.1:5060)
Domain name (e.g., nat.company.com)
{SIP address}:{port} (e.g., sip:nat@company.com:5065)
Re-registration
time
Enter the number of seconds that will determine the frequency of
handset re-registrations with the SIP Server. If the number of seconds is
less than 600, then the frequency will be half of the number of seconds.
If the number of seconds is 600 or greater, then the frequency will be
the value minus 300 seconds. As examples, if the entered number of
seconds is 500, then the re-registration frequency will be 500/2 = 250
seconds. If the number of seconds is 700, then the re-registration
frequency will be 700 – 300 = 400 seconds.
Keep Alive
If you want the base to send Keep Alive messages, select
Enable
.
They will be sent according to the frequency specified on the
Network Settings screen.
If you do not want the base to send Keep Alive messages, select
Disable
.
DTMF Signalling
Select the type of DTMF signalling used by the SIP server:
SIP INFO
: DTMF tones are sent along the SIP signalling path.
RFC 2833
: DTMF tones are sent via data packets in a different
Internet layer from the voice stream.
Both
: DTMF tones are sent both in the SIP signalling path (SIP INFO
mode) and via data packets (RFC 2833 mode).
Codec Priority
Set the priority order of the voice codecs in use by the SIP server. To
change the priority of the codecs, select a codec and click Up to move
that codec up the priority list, Down to move it down the priority list,
or Remove to remove the codec from the list. To restore the codec list
to its original values and order, click Reset.