EXP1240 System Installation Guide Revision 06
© 2013 Uniden America Corp. PROPRIETARY AND CONFIDENTIAL Page 36 of 71
Figure 27:
Base Station Group
table, Level 1 complete (
Multi-cell
screen)
Configuring Base Stations at Level 2 and Up
1) Place the first Level 2 base station at its final location. (See the Network Planning Guide
for information on the proper placement of base stations.)
2) Login to the base station.
3) Reset the base station to its default settings (open the
Management
screen and click
Default Base Station). If this base station has never been configured, skip this step.
4) Go to the
Multi-cell
screen and set the
Multi cell system
field to
Enable
.
5) Enter the
System chain ID
and select a
Multi Cell
debug setting only if necessary.
6) Click Save and reboot the base station.
7) Allow several minutes for the base station to reboot, then go back to
Multi-cell
screen
and check the
Base Station Group
table.