Filter
Top Products
EXP1240 System Installation Guide Revision 06
© 2013 Uniden America Corp. PROPRIETARY AND CONFIDENTIAL Page 11 of 71
1) Connect a standard Ethernet cable (Cat 5 or higher) to the Ethernet/PoE jack on the
rear of the base station. Route the cable through the channel as shown below.
Figure 3 Connecting the base station
2) Connect the other end of the cable to your TCP/IP network.
When the base station powers on, the STATUS LED on the front briefly lights orange and
then turns off while it initializes and connects to the network. After the base station
successfully initializes and connects to the network, the LED lights green and remains
steady on.
Table 3: Base station LEDs and their meanings
Color State Meaning
Green Flickering Firmware update in progress
Green Steady on All operations normal.
(NA) Off
No power in unit
OR
Initializing and connecting to the network.
Orange Briefly on Powering on
Orange Flickering Firmware update in progress