Uniden EXP1240 Two-Way Radio User Manual


 
EXP1240 System Installation Guide Revision 06
© 2013 Uniden America Corp. PROPRIETARY AND CONFIDENTIAL Page 16 of 71
Table 4: Summary: Basic system configuration
Step Screens used
Notes
General System Settings
1. Change the name that appears at the top
of the configuration screens, specify a
configuration server, and enable SIP and
system logs.
Management
Required
2. Change the default user name and
password.
Web Security
Recommended
3. Change the PSTN tones and emergency
dialing format.
Country
Required for countries other
than the US and Canada
4. Configure basic network settings. Network Required
5. Specify time server address and DST
settings.
Time
Settings
Required (If you are updating
Server information, you must
reboot the base station for
changes to take effect.)
SIP Server Settings
6. Program the SIP server(s).
Network
Servers
Required (You must reboot the
base station for changes to
take effect).
7. Program extensions on each SIP server. Extensions Required
8. Register a handset to each extension. Extensions Required
Using the Base Station Interface
Each base station has a built-in HTTP server that controls the configuration interface. To
open the web page:
1) Open a web browser window and type the IP address of the base station in the address
bar. If you don't know the base station's IP address, try one of the following:
Use the IP Search function on the handsets. On any handset, press Menu (
), then enter
*47* (*IP*)
. After several seconds, the handset displays the
MAC and IP addresses of all base stations within range. Find the MAC
address of the base station in the list to determine its IP address. To exit IP
Search, press End ( ) twice.