EXP1240 System Installation Guide Revision 06
© 2013 Uniden America Corp. PROPRIETARY AND CONFIDENTIAL Page 38 of 71
3) Check the
Extensions
screen to see if any extensions are registered to the base station to
be removed. The State column displays which base station the handset extensions are
registered.
4) Physically move the handsets registered to those extensions out of this base station's
coverage area and place them next to a different base station. Wait for the handsets to
change their registration to the new base station. Alternatively, power off the handsets,
and power them on near the different base station.
5) In the
Base Station Group
table, check to see if the base station you want to remove is
serving as the synchronization source for any other base station(s). If necessary, select a
new
DECT sync source
for any affected base stations, and click Save.
6) Click the check box beside the base station you want to remove from this chain, then
click
Remove from chain
. (Be sure you do not check the base station with ID 0/RPN00.)
7) Login to the base station just removed. On the
Home/Status
screen, verify that it reads
Multi Cell disabled
on the
System Information
line
8) For use in another chain, reset the base station to its factory default settings (go to the
Management
screen and click Default Base Station).
∘ When the base station finishes rebooting, login and check the Home/Status
screen. The base station name at the top of the screen should read
SME VoIP
and the
System Information
field should still read
Multi cell Disabled
.
9) Log out of the base station, and repeat this procedure on any other base stations you
want to remove from system.
Changing the Primary Base Station in a Chain
Only perform this procedure when the system is offline or in a maintenance
period.
1) Log in to a base station in the chain.
2) Go to the
Multi Cell
screen.
3) In the Base Station Group table, determine which base station you want to become the
new primary base station.
4) Select this base station's own RPN as the
DECT Sync Source
.
5) For the original Primary base station, select the new Primary or another base station
within its range as its
DECT Sync Source
.
6) Click Save.
7) Login to the original primary base station, and go to the
Multi Cell
screen.
8) Click Reboot.