Uniden EXP1240 Two-Way Radio User Manual


 
EXP1240 System Installation Guide Revision 06
© 2013 Uniden America Corp. PROPRIETARY AND CONFIDENTIAL Page 32 of 71
Configuring the Primary Base Station
You will need to perform the following steps on the primary base station only. See page
33 for information on all other base stations.
1) Place the primary base station at its final location. (See the Network Planning Guide for
information on the proper placement of base stations.)
2) Login to the base station.
3) In the left hand panel, click on
Multi cell
. This opens the
Multi-cell
screen.
Figure 22:
Multi-cell
screen (default values)
4) Set the
Multi cell system
field to
Enable
.
5) In the
System chain ID
field, enter the unique identifier of the chain this base station
should belong to. Acceptable ID values range from 0 to 99999.
6) In the
Synchronization time(s)
, change the number of seconds between each time this
base station re-synchronizes with the other base stations in this chain (if necessary).