EXP1240 System Installation Guide Revision 06
© 2013 Uniden America Corp. PROPRIETARY AND CONFIDENTIAL Page 21 of 71
2) Enter the correct settings for your network and click Save. Refer to Appendix A:
Software Reference on page 46 if you need more information on these fields.
Normally, you need to reboot the base station to activate new network settings.
However, during initial configuration, wait until you configure the rest of the screens
before rebooting. (Changing the
Time Settings
, for instance, will force a reboot.)
Configure Time Settings
1) In the left hand panel, select
Time
. This opens the
Time Settings
screen.
Figure 14:
Time Settings
screen
2) In the
Time Server
field, enter the IP address or URL of the server that distributes
reference clock information for your network. This server must be visible to the base
stations at all times.
3) In the
Time server refresh interval
field, change the number of hours the base should
wait before it checks the time server again (if necessary).
4) In the
Timezone
field, select the number of hours the local time zone differs from
GMT/UTC time. For example, US Central Standard Time (CST) is 6 hours behind UTC, so
you would set the
Timezone
field to
−
6:00
.
5) Enter any necessary settings for Daylight Savings Time, then click Save & Reboot. (If
you need more information on these fields, refer to Appendix A: Software Reference on
page 46.)