Filter
Top Products
Part 3 – AT Commands Wi-Fi Devices Chapter 13 – WLAN AT Commands for the SocketWireless Wi-Fi
Universal IP AT Commands Reference Guide (Document S000457K) 67
#WLANCONNECT – Connect with AP
Description: Connects the module with AP.
Syntax: AT#WLANCONNECT
Values: None
Example: AT#WLANCONNECT
SSID : WestConfRoom
RSSI : -52
Network : BSS
Security : No Enc
Capability : 0x1
Channel : 5
WLAN Mode : B Mode
BSSID : 00:13:D3:7B:A3:6A
OK
#WLANDISCONNECT – Disconnect with AP
Description: Disconnects the module with AP.
Syntax: AT#WLANDISCONNECT
Values: None
Example: AT#WLANDISCONNECT
OK
#WLANENABLE – Auto Connect Module with AP
Description: On power up, this parameter determines whether to connect to the AP automatically or manually.
Connection to the AP can be established by AT#WLANCONNECT command. A value of 0
means the module will not connect to AP automatically. A value of 1 means that on power up the
module tries to connect to the AP for configured settings.
Note: The module must be reset to put the command into effect.
Syntax: AT#WLANENABLE=<value>
AT#WLANENABLE? Read or display the current setting.
Values: 0 - Manual connection to the AP
1 - Automatic connection to the AP
Default: 0
#WLANDOZE= – Moves Module into or out of Power Save
Description: This command moves the module into or out of Power Save during an active connection.
Syntax: AT#WLANDOZE=
AT#WLANDOZE? Read or display the current setting.
Values: 0 - Power active mode
1 - Power doze mode