Filter
Top Products
Part 1 – AT Commands for All Universal IP Devices Chapter 1 – General AT Commands for All Universal IP Devices
Universal IP AT Commands Reference Guide (Document S000457K) 15
#ESCAPECHAR – Configure the Escape Character for DLEMODE
Description: This parameter defines the escape character for the clients that use an escape character (also
known as DLE shielding with regards to Universal IP.
Note: This command is for all devices except the SocketWireless Wi-Fi (MT810SWM-IP)
Syntax: AT#ESCAPECHAR=<parameter1>
AT#ESCAPECHAR?
Values: 0-255; Integer value between 0 and 255
Responses: \r\n#ESCAPECHAR: VALUE\r\n
\r\nOK\r\n
\r\nERROR\r\n
Examples:
send: AT#ESCAPECHAR=3\r
reply: \r\nOK\r\n
send: AT#ESCAPECHAR?\r
reply: \r\n#ESCAPECHAR: 3\r\n
reply: \r\nOK\r\n
Display Commands
#VSHOWSERIAL – Display RS-232 Signal Status of the User Serial Port
Description:
Displays the RS-232 signal status; used for engineering.
Note: This command is for all devices except the SocketWireless Wi-Fi (MT810SWM-IP)
Syntax: AT#VSHOWSERIAL
Values: na
Responses: \r\SERIAL information\r\n
\r\nOK\r\n
\r\nERROR\r\n
Examples:
send: AT#VSHOWHARDWARE\r
reply: \r\n+-------------------------------+------------------------------------------+\r\n
reply: \r\n| Serial EIA Signal Status (DCE interface) |\r\n
reply: \r\n+-------------------------------+------------------------------------------+\r\n
reply: \r\n| CTS : ON |\r\n
reply: \r\n| DSR : OFF |\r\n
reply: \r\n| DCD : OFF |\r\n
reply: \r\n| RTS : ON |\r\n
reply: \r\n| DTR : ON |\r\n
reply: \r\n+-------------------------------+------------------------------------------+\r\n
reply: \r\nOK\r\n