Filter
Top Products
Part 6 – AT Commands for GPS-Enabled Devices Chapter 16 – AT Commands for GPS-Enabled Devices
Universal IP AT Commands Reference Guide (Document S000457K) 93
#GPSURAIS – Set GPS Unique Remote Asset Identification String
Description: This command is used to set a unique remote access identification string for each device or
vehicle.
Syntax: AT#GPSURAIS="<value>"
AT#GPSURAIS? or AT#VGPS or AT#VALL
Values: Up to 20 characters in an alphanumeric string
Note: The ID precedes the GPSPREFIX.
Default: " "
Responses: OK
Otherwise ERROR
#GPSINTERVAL – Set GPS Server Transmission Interval
Description: This command sets the interval of time between messages transmitted to the server.
Syntax: AT#GPSINTERVAL=<value>
AT#GPSINTERVAL? or AT#VGPS or AT#VALL
Values: 0 to 65535 (seconds)
Default: 0 (Disabled)
Responses: OK
Otherwise ERROR
#GPSPW – Set GPS Host Login Password
Description: This command sets the GPS host login password, if required. Some GPS hosts may require a
simple password login mechanism.
Syntax: AT#GPSPW="<value>"
AT#GPSPW? or AT#VGPS or AT#VALL
Values: Alphanumeric ASCII text string up to 64 characters.
Default: None
Responses: OK
Otherwise ERROR
#GPSGPGGA – Enable/Disable GPGGA Message
Description: This command enables or disables the reporting of NMEA GPGGA messages.
Syntax: AT#GPSGPGGA =<value>
AT#GPSGPGGA? or AT#VGPS or AT#VALL
Values: 0 Disable
1 Enable
Default: 1
Responses: OK
Otherwise ERROR