Filter
Top Products
Part 1 – AT Commands for All Universal IP Devices Chapter 1 – General AT Commands for All Universal IP Devices
Universal IP AT Commands Reference Guide (Document S000457K) 16
#VSHOWUPTIME – Displays the Current Uptime in Days, Hours, Minutes, Seconds
Description:
Displays the current uptime of the UIP stack.
Note: This command is for all devices except the SocketWireless Wi-Fi (MT810SWM-IP)
Syntax: AT#VSHOWUPTIME
Values: na
Responses: \r\nVALUE\r\n
\r\nOK\r\n
\r\nERROR\r\n
Examples:
send: AT#VSHOWUPTIME\r
reply: \r\n00000:00:03:46\r\n
reply: \r\nOK\r\n
#VSHOWUPTIMES – Displays the Current Uptime in Seconds
Description:
Displays the current uptime of the UIP stack in seconds.
Note: This command is for all devices except the SocketWireless Wi-Fi (MT810SWM-IP)
Syntax: AT#VSHOWUPTIMES
Values: na
Responses: \r\nVALUE\r\n
\r\nOK\r\n
\r\nERROR\r\n
Examples:
send: AT#VSHOWUPTIMES\r
reply: \r\n304\r\n
reply: \r\nOK\r\n
#VVERSION – Display Software Version
Description: This command directs the TCP/IP stack to display the software version.
Syntax: AT#VVERSION
Values: No TCP/IP parameters.
#VSTATE – Display Current State of Physical Connection
Description: This command displays the status of the physical network connection.
Note: This command is for all devices except the SocketWireless Wi-Fi (MT810SWM-IP).
Syntax: AT#VSTATE
Possible Responses:
#STATE: "IDLE" Physical connection is idle and ready to connect
#STATE: "DIALING" Physical connection is attempting to contact the network
#STATE: "AUTHENTICATING" Physical connection is complete; PPP authentication is being
performed
#STATE: "CONNECTED" Physical connection is complete and PPP negotiation is
complete; stack is ready for client commands
#STATE: "DISCONNECTING" Physical connection is in the process of disconnecting from the
network
#STATE: "DISCONNECTED" Physical connection is disconnected from the network (Only
used on the MT100SEM-IP)
#STATE: "CHECKING" Checking current status; try again