Filter
Top Products
Part 6 – AT Commands for GPS-Enabled Devices Chapter 16 – AT Commands for GPS-Enabled Devices
Universal IP AT Commands Reference Guide (Document S000457K) 97
GPS Configuration Examples
AT#GPSPREFIX="&&"<CR> Prefix (Requirements provided by backend service)
AT#GPSURAIS="ID1111"<CR> Unique ID (Requirements provided by backend service)
AT#GPSGPRMC=1<CR> Enable GPRMC message (Requirements provided by backend
service)
AT#GPSGPGGA=0<CR> Disable GPGGA message (Requirements provided by backend
service)
AT#GPSGPGLL=0<CR> Disable GPGLL message (Requirements provided by backend
service)
AT#GPSGPGSA=0<CR> Disable GPGSA message (Requirements provided by backend
service)
AT#GPSGPGSV=0<CR> Disable GPGSV message (Requirements provided by backend
service)
AT#GPSGPVTG=0<CR> Disable GPGLL message (Requirements provided by backend
service)
AT#VGPS<CR> View settings
The following command starts the GPS sending. The message will be sent if the UIP device is
connected to the network. (CONNECTIONSTART has been issued)
AT#GPSINTERVAL=5<CR> Timer in seconds that the device will contact the remote server
AT#GPSINTERVAL=0<CR> Disables sending messages
The following example message would be sent over the network using UDP every 5 seconds (The
$GPRMC would have different data however).
&&ID1111$GPRMC,223750.00,A,4502.2467,N,09302.4844,W,57.00,97.29,131104,2.5,E,A*20<CR><LF>