Multi-Tech Systems iCell GPRS (MTSMC-G2-IP Wireless Office Headset User Manual


 
Part 6 AT Commands for GPS-Enabled Devices Chapter 16 – AT Commands for GPS-Enabled Devices
Universal IP AT Commands Reference Guide (Document S000457K) 92
Chapter 16 – AT Commands for GPS-
Enable Products
#GPSSERVSet GPS Host Server Address
Description: This command sets the server IP address or name to which the GPS data will be sent.
Syntax: AT#GPSSERV="<value>"
AT#GPSSERV? or AT#VGPS or AT#VALL
Values: 32-bit number in dotted-decimal notation (i.e., xxx.xxx.xxx.xxx) or
Alphanumeric ASCII text string up to 120 characters if DNS is available. No default.
Responses: OK
Otherwise ERROR
#GPSPORTSet GPS Host Port
Description: This command sets the GPS host port (TCP, UDP).
Syntax: AT#GPSPORT=<port number>
AT#GPSPORT? or AT#VGPS or AT#VALL
Values: 1 to 65535
Default: 1
Responses: OK
Otherwise ERROR
#GPSPROTOSet GPS Host Protocol
Description: This command sets the server protocol that the GPS will use (TCP, UDP).
Syntax: AT#GPSPROTO=<value>
AT#GPSPROTO? or AT#VGPS or AT#VALL
Values: 0 UDP
1 TCP
Default: 0
Responses: OK
Otherwise ERROR
#GPSPREFIXSet GPS Message Prefix
Description: This command is used to set a unique identification for each device or vehicle.
Syntax: AT#GPSPREFIX="<value>"
AT#GPSPREFIX? or AT#VGPS or AT#VALL
Values: Up to 4 characters in an alphanumeric string
Note: The prefix is appended to the NMEA message before transit
Default: " "
Responses: OK
Otherwise ERROR