Filter
Top Products
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Setting Up IOS Access Points
5-16
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Step 9 The WDS access point must also register and authenticate itself to the WDS to
participate in the SWAN hierarchy; therefore, the WDS AP is also an
infrastructure AP. To configure the WDS access point as an infrastructure access
point:
wlccp ap username
username
password
password
Note To configure authentication for wireless clients, see the relevant AP
documentation.
Using a WLSE Configuration Template to Configure WDS Access Points
You can use the WLSE to configure one or more WDS access points.
The major configuration steps are:
• Create a configuration template to set up AAA servers and the WDS.
• Apply the configuration template to the appropriate access points by running
a configuration job.
To configure WDS access points by using a WLSE configuration template:
Step 1 Log in to the WLSE web interface.
Step 2 Select Configure > Templates.
a. Enter a template name, selecting IOS as the template type.
b. Click Create New.
Step 3 Enter the AAA servers for LEAP authenticating the infrastructure access points
and the WLSE to the WDS, and the AAA servers for authenticating wireless client
devices:
a. Select Security > Server Manager.
b. In the Corporate Servers section, for each server, enter the IP address, select
RADIUS, and enter the shared secret.
c. Click Save.
Step 4 Select Wireless Services > WDS to configure the WDS parameters.