Filter
Top Products
Chapter 3 Installing WLSE 1130-19 Hardware
Installation Quick Reference
3-2
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Installation Quick Reference
Table 3-1 provides a high-level overview of the installation process. After
installation is complete, follow the directions in Chapter 4, “Basic
Setup—CiscoWorks 1105/1130/1130-19.”
Installing the WLSE 1130-19 in a Rack
This section provides instructions for installing the WLSE in a rack. The rack
must be properly secured to the floor, ceiling, or upper wall, and where applicable,
to adjacent racks. The rack should be secured using floor and wall fasteners and
bracing specified by industry standards.
Before installing the WLSE in a rack, read Preparing Your Site for Installation,
page 2-7 to familiarize yourself with the proper site and environmental
conditions. Failure to read and follow these guidelines could lead to an
unsuccessful installation and possible damage to the system and components.
Perform the steps below when installing and servicing the WLSE.
The rack must be properly secured to the floor, to the ceiling or upper wall, and
where applicable, to adjacent racks. The rack should be secured using floor and
wall fasteners and bracing specified or approved by the rack manufacturer or by
industry standards.
Table 3-1 Quick Reference
Task References
Use the rack mount kit to install
the WLSE in a rack.
Installing the WLSE 1130-19 in a Rack,
page 3-2
Connect the WLSE to an AC
power source.
Connecting Cables, page 3-15
Connect network and console
cables.
Connecting Cables, page 3-15
Power on the WLSE. Powering On the WLSE, page 3-16