Filter
Top Products
2-5
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Chapter 2 Preparing to Install WLSE 1130-19 Hardware
Safety
Technical Assistance Center. For instructions on contacting the Technical
Assistance Center, see the section Obtaining Technical Assistance,
page -xxiii in the Preface.
• Do not push any objects into the openings of your system components. Doing
so can cause fire or electric shock by shorting out interior components.
• Position system cables and power cables carefully; route system cables and
the power cable and plug so that they cannot be stepped on or tripped over.
Be sure that nothing rests on your system components’ cables or power cable.
• Do not modify power cables or plugs. Consult a licensed electrician or your
power company for site modifications. Always follow your local/national
wiring rules.
• To help avoid possible damage to the system board, wait 5 seconds after
turning off the system before removing a component from the system board
or disconnecting a peripheral device from the computer.
Maintaining Safety with Electricity
Follow these guidelines when working on equipment powered by electricity:
• If any of the following conditions occur contact the Cisco Technical
Assistance Center:
–
The power cable or plug is damaged.
–
An object has fallen into the product.
–
The product has been exposed to water.
–
The product has been dropped or damaged.
–
The product does not operate correctly when you follow the operating
instructions.
• Use the correct external power source. Operate the product only from the type
of power source indicated on the electrical ratings label. If you are not sure
of the type of power source required, consult the Cisco Technical Assistance
Center or a local power company.
• Use only approved power cable(s). If you have not been provided with a
power cable for your computer or storage system or for any AC-powered
option intended for your system, purchase a power cable that is approved for
use in your country. The power cable must be rated for the product and for the