Filter
Top Products
Chapter 6 Setting Up Discovery and Device Management—CiscoWorks 1105/1130/1130-19
Adding Device Credentials to the WLSE
6-4
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Step 2 To add a username and password:
a. Enter the access point IP address or range of IP addresses that will use this
username and password.
b. Enter the username.
c. Enter the password.
d. Click Save. The IP address and username are added to the Current Entries
textbox.
Step 3 Repeat step 2 to add credentials for more devices.
Enter Telnet or SSH Credentials for IOS Access Points
Telnet/SSH credentials are used for downloading configuration files to IOS-based
access points and for upgrading firmware on IOS access points.
Note When entering Telnet or SSH credentials, enter data only in the fields that
correspond to the login sequence on the access point(s). For example, if the access
point does not prompt for a user name, do not enter a user name.
To enter Telnet or SSH credentials:
Step 1 Select Devices > Discover > Device Credentials > Telnet/SSH User/Password.
Step 2 To add a username and password:
a. Enter the access point IP address or range of IP addresses that will use this
username and these passwords.
b. Enter the username.
c. Enter the password and confirm it.
d. Enter the enable password and confirm it.
e. Click Save. The IP address, username, and passwords are added to the
Current Entries textbox.