Filter
Top Products
Chapter 4 Basic Setup—CiscoWorks 1105/1130/1130-19
Configuring the WLSE’s Network Information
4-2
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Configuring the WLSE’s Network Information
Use the setup program to configure the WLSE when you boot it for the first time,
and after erasing the configuration.
Guidelines for Using the Setup Program
When using the setup program:
• Press the Backspace or Delete key to delete characters when entering a
response to a prompt.
• You cannot edit a response after you press the Enter key. You can use CLI
commands to change some responses after running setup; see Changing the
Configuration After Running Setup, page 4-5.
• Exit the setup program in two ways:
–
Press Ctrl-c.
The login prompt appears. Log in as the user setup to rerun the setup
program.
–
Enter no at the final prompt:
Would you like to save this configuration? [yes].
The setup program exits without saving the configuration, then restarts.
See Table 4-2 on page 4-3 and Table 4-3 on page 4-4 for the data you will need to
enter into the setup prompts.
Running the Setup Program
To configure WLSE network information, perform the following steps:
Step 1 Connect a console to the serial/console port on the back panel.
• For the CiscoWorks 1105, use the serial port on the front panel. Do not use
the serial port on the back panel as a console port.
• For the CiscoWorks 1130 or 1130-19, use the serial port on the back panel.