Filter
Top Products
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Setting Up IOS Access Points
5-8
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Note If you do not wish to use CDP, you can add all access points as seeds or
import devices. For more information, see Discovering Devices, page 6-7.
Step 3 You can use either Telnet or SSH (secure shell protocol) to push configuration
templates to IOS access points. To use templates to configure IOS access points,
you must configure either Telnet or SSH or both.
• To enable and configure SSH (secure shell protocol), enter the following:
1. Select SERVICES > Telnet/SSH.
2. Enable Secure Shell.
3. Enter a System Name.
4. Enter a Domain Name (for example, cisco.com).
5. (Optional) Enter the RSA key size.
6. (Optional) Enter the Authentication Timeout.
7. (Optional) Enter Authentication Retries.
8. Click Apply.
• To enable and configure Telnet:
1. Select SERVICES > Telnet/SSH.
2. Enable Telnet.
3. (Optional) Enable Teletype.
4. Enter the number of Columns.
5. Enter the number of Lines.
6. Click Apply.
Step 4 To enable SNMP:
a. Select Services > SNMP.
b. After Simple Network Management Protocol (SNMP), select Enabled.
c. Enter the System Name (sysName), System Location (sysLocation), and
System Contact (sysContact).
d. Click Apply.