Filter
Top Products
5-9
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Setting Up IOS Access Points
Step 5 In the SNMP Request Communities section, enter a read-only community string.
This community string is required for discovery and the fault and report features.
a. Enter the community string in the SNMP Community field.
b. Enter iso in the Object Identifier field.
Note IOS access points that do not have an ISO view will be placed in the
Misconfigured Devices system group after discovery, and a fault will
be generated. The fault message refers to a “dot11 MIB problem.”
c. Select Read-Only.
d. Click Apply.
Step 6 In the SNMP Request Communities section, enter a read/write community string.
This community string is required for all radio-management features.
a. Enter the community string in the SNMP Community field.
b. Select Read-Write.
c. Enter iso in the Object Identifier field.
d. Click Apply.
Step 7 The community strings created in Steps 5 and 6 must be entered on the WLSE
before the device can be discovered and the other WLSE features can be used. For
more information, see Enter SNMP Community Strings for All Managed Devices,
page 6-2.
Using WLSE Configuration Templates for Network Management Set Up
You can perform initial configuration by using the WLSE’s startup template
feature. For information on using a startup template, see the online help or the
“Managing Device Configuration” chapter in the User Guide for the CiscoWorks
Wireless LAN Solution Engine, Release 2.7.