Filter
Top Products
6-9
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Chapter 6 Setting Up Discovery and Device Management—CiscoWorks 1105/1130/1130-19
Discovering Devices
Step 4 Add community strings for all of the devices to be discovered if you have not
already done so. For details on adding community strings, see Enter SNMP
Community Strings for All Managed Devices, page 6-2. After adding community
strings, click Next.
Step 5 Add one or more initiating IP addresses (seeds) to be used for this one-time
discovery only:
Note If CDP is not enabled, you still can discover devices by entering each of
their IP addresses as seeds, however the connectivity between switches
and access points will not be discovered.
a. Enter the IP addresses or device names in the Add Seed Values text box and
click >>.
b. Set the CDP distance. If the distance is set to 1, only the immediate neighbors
of the seed devices are discovered. Set the distance appropriately to discover
the entire wireless network. Set the distance to 1 if you are adding all devices
as seeds.
Note Routers and switches that do not have access points attached to them
are used when computing CDP distance. However, such devices will
not appear in the discovered devices list.
c. Click Next.
Step 6 If the discovery summary is correct, click Finish to run the discovery. The
discovery will begin within 2 minutes.
If the summary is not correct, click Back to make changes in any of your settings.
Step 7 A popup message displays the name of the discovery and the Discovery Run
Details window appears. Click Refresh to update the Job Run Log.