Filter
Top Products
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Setting Up Routers and Switches
5-24
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Setting Up Routers and Switches
Note Only routers and switches that have properly configured access points or bridges
attached to them will be discovered.
Configure each router and switch as shown in Table 5-4 on page 5-24.
Table 5-4 Setup Procedures for Routers and Switches
Task Procedure Notes
1. Enable CDP and
verify that access
points and bridges
are visible from the
router or switch.
1. In enable mode, verify that CDP is running on the
device by using one of the following commands:
• On IOS-based devices—show cdp run.
• On Hybrid OS-based Catalyst
switches—show cdp.
2. If CDP is not running, in global configuration mode,
enter cdp run to enable CDP.
3. To verify that access points or bridges are visible in
the device’s CDP table, enter show cdp neighbors.
CDP is required for
the WLSE to discover
the device.
2. Enable SNMP
and set up
community strings.
On IOS-based devices, enter configuration mode and use
the snmp community community_string ro command.
On Hybrid OS-based Catalyst devices, enter enable
mode and use the set snmp community read-only
community_string command.
SNMP is required for
the WLSE to discover
and manage the
device.