Filter
Top Products
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Setting Up IOS Access Points
5-6
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Step 4 To configure SNMP, enter the following commands in the sequence shown. The
first command includes the ISO view. The read-only community string, is
required for discovery and the fault and report features on the WLSE. The
read/write community string is required for AP firmware management, AP
configuration, and all radio-management functions (client walkabout, radio
scanning, and so on).
a. Include the ISO view:
snmp-server view iso iso included
a. Configure the read-only community:
snmp-server community
ro_ommunity_string
view iso ro
b. Configure the read/write community:
snmp-server community
rw_community_string
view iso rw
Note The community strings must also be entered on the WLSE. See Enter
SNMP Community Strings for All Managed Devices, page 6-2.
Caution IOS access points that do not have an ISO view will be placed in the
Misconfigured Devices system group after discovery and a fault will be generated.
The fault refers to a “dot 11 MIB” problem.
Step 5 (Optional) It is useful to set the system name, contact, and location SNMP
variables to make the device more manageable. Use the following commands:
configuration terminal
hostname
access_point
snmp-server location
AP_location
snmp-server contact
AP_contact
where access_point is the system name, AP_location is its location, and
AP_contact is the name of the contact person.
Step 6 You can use either Telnet or SSH to push configuration templates to IOS access
points. To use templates to configure IOS access points, you must configure either
Telnet or SSH or both, as follows.