Filter
Top Products
CHAPTER
5-1
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
5
Setting Up Devices—CiscoWorks
1105/1130/1130-19
You must set up devices before the WLSE can discover and manage them and
before you can use WLSE features such as monitoring, reporting, configuration,
firmware upgrade, and radio management. This section describes initial setup
tasks for the following devices:
• Non-IOS access points and bridges—See Setting Up Non-IOS Access Points
and Bridges, page 5-1
• IOS access points and bridges—See Setting Up IOS Access Points, page 5-4
• Routers and switches—See Setting Up Routers and Switches, page 5-24
• AAA servers—Setting Up AAA Servers, page 5-25
Setting Up Non-IOS Access Points and Bridges
This section provides setup procedures to prepare non-IOS access points for basic
network management by the WLSE. You can perform initial setup in two ways:
• Open a web browser session on each access point—See Set Up Using the
Web Interface, page 5-2.
• Use the WLSE startup configuration option for first-time device
configuration and apply a configuration template to a number of access
points—See Set Up Using a WLSE Configuration Template, page 5-4.